Pdating powered by vbulletin
Pump- I took out some extra stuff on the steps from their PDF’s because it actually was easier. After updating firmware you should find that you have not lost any of your map, settings, or throttle position. Next Step: CLOSE PCIII software to install the Accelerator pump - I didn’t and it kept pulling up errors. I set mine to: As for the Accell Pump Feature- the butt dyno says it’s working.There will be a separate utility to install the pump- I saved mine to the desktop. Didn’t add any power but it made acceleration from a light a little stronger, and took care of my 1100-1500 pinging as I pulled away from lights.I'm currently with it and it works perfectly on my G75VW. I said it worked after using the setup installer rather than pdating them manually via device managerdid you read what i typed in the Edit? device manager uninstall, reboot then install the new version? device manager uninstall, reboot then install the new version?
I have no idea about the changes, so it would be nice if someone posted a changelog. v_page=23&v_code=35653&v_langue=en I tried installing it and it doesn't work! EDIT: Nevermind, it seems that trying to manually install it via device manager doesnt work but if you use the setup installer it works fine That's strange.[Added} here's the info on the version numbers: Warrior Fuel Managers (click Firmware Update pdf).I ran with the Accelerator Pump function installed and enabled for a couple years.(Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc.And, post in the customizations forum instead if any customizations are active.)Discussion related to the Sage TV Placeshifter application produced by Sage TV. relating to the Sage TV Placeshifter software application should be posted here.